The Hallite 58 double acting piston seal combines the Hallite 56 seal with bearing rings to give a very robust heavy duty seal assembly for split pistons. It enables the designer to use large clearances and, with the integral bearing rings, to restrict the piston length.
The assembly comprises a seal and two L shaped bearings. The centre of the seal is rubber which is bonded to two ‘U’ section bases of rubberised fabric, and is compressed by the housing to obtain an effective low pressure seal. When the pressure increases the rubber energises the ‘U’ section and deforms it to the housing, increasingthe sealing area and improving the seal.
Rubberised fabric is used to protect the rubber, because it has strength and durability which combines with its ability to retain lubricant to help keep friction low and reduce wear.
Supporting the seal at either end is a polyacetal bearing proportioned to react to the pressure on the seal to prevent extrusion damage, and support the piston in its side load.
- Not Suitable
* For fluid types marked as possible, please call our team of experts on +1 248 668 5220 to talk through your requirements and determine if this seal is the most suitable for your needs.
|Dynamic application||Static application|
|Fluids based on mineral oil|
|HFB (60/40 invert emulsion)||Recommended||Recommended|
|HFC (water glycol)||Recommended||Recommended|
|Other fluid types|
|HFD (Phosphate ester ARYL Type)||Not suitable||Not suitable|
|Synthetic esters (HEES, HFDU)||Possible||Possible|