50

The Hallite 50 is a double acting seal designed for light duty applications using either one piece or split pistons to ISO 6547 housings.

It comprises a rubber seal, two split support rings and two split bearings, located either side of the seal. The nitrile rubber seal has proved itself to be extremely wear resistant in service.

It is designed to be compressed by the housing to ensure a low pressure seal and when pressurised be protected from extrusion damage by the extending lips of the support ring. A tough flexible polymer is used for the support ring which is scarf cut for assembly and to protect the seal from damage.

A rectangular reinforced nylon bearing completes the assembly and provides the seal and piston with support and guidance.

The proportions of this range of piston seals have been determined to give a satisfactory performance when used with recommended operating conditions.

Note: Other sizes of this design of seal are shown under Hallite 53, 64 and 68.

Filter

  • Unit of measurement:
Unit of measurement:

Max pressure

350 Bar

Temp range

-30°C
100°C

Max speed

0.5m/sec
Key:
  • Recomended
  • Possible
  • Not Suitable

* For fluid types marked as possible, please call our team of experts on +39 (0)58 642 8287 to talk through your requirements and determine if this seal is the most suitable for your needs.

  Dynamic application Static application
Fluids based on mineral oil    
Any Recommended Recommended
Waterbased fluids    
HFA (5/95) Possible Recommended
HFB (60/40 invert emulsion) Recommended Recommended
HFC (water glycol) Possible Possible
Water Possible Recommended
Other fluid types    
Air/Nitrogen Not suitable Possible
HFD (Phosphate ester ARYL Type) Not suitable Not suitable
Synthetic esters (HEES, HFDU) Possible Possible