68

A robust seal assembly designed specifically for one piece pistons, the Hallite 68 double acting seal uses a rubber sealing element which has proved itself in service to be extremely wear resistant and capable of working most effectively in a wide variety of medium to heavy duty applications. The seal is also suitable for two piece pistons.

The assembly comprises a rubber seal, two split support rings and two split bearings, one of each located either side of the seal. The nitrile rubber seal is designed to have its section compressed by the housing, to ensure a low pressure seal, and when pressurised be protected from extrusion damage by the extending lips of the support ring. The support ring is manufactured from a tough but flexible polymer and scarf cut for assembly.

Polyacetal rectangular section bearings provide the support and guidance for the piston and the other parts of the seal.

Other sizes of this design of seal are shown under Hallite 50, 53 and 64.

Filter

  • Unit of measurement:
Unit of measurement:

Max pressure

500 Bar

Temp range

-30°C
100°C

Max speed

0.5m/sec
Key:
  • Recomended
  • Possible
  • Not Suitable

* For fluid types marked as possible, please call our team of experts on (02) 9620 7300 to talk through your requirements and determine if this seal is the most suitable for your needs.

  Dynamic application Static application
Fluids based on mineral oil    
Any Recommended Recommended
Waterbased fluids    
HFA (5/95) Possible Recommended
HFB (60/40 invert emulsion) Recommended Recommended
HFC (water glycol) Possible Possible
Water Possible Recommended
Other fluid types    
Air/Nitrogen Not suitable Possible
HFD (Phosphate ester ARYL Type) Not suitable Not suitable
Synthetic esters (HEES, HFDU) Possible Possible