The Hallite 83 Tri-Seal assembly offers the engineer many advantages when considering the design of cast iron, bronze, alloy etc. one-piece pistons in double-acting hydraulic cylinders, not the least being cost effectiveness with long and efficient seal life.

The Tri-Seal consists of two split plastic anti-extrusion rings and a nitrile synthetic rubber sealing member. Under pressure, the seal exerts a wedging action on the anti-extrusion ring, reducing the clearance between the cylinder bore and the piston, thus minimising the possibility of extrusion of the seal.

Wear rings are also available for this assembly, allowing the designer to benefit from the following advantages:

•  Eliminate metal to metal contact in the bore
•  One piece steel piston
•  Improved alignment for optimum seal life
•  Smoother operation

Note: For availability of sizes not listed please consult your local Hallite sales department.

When ordering Hallite 83 with wear rings please replace the last digit of the part number as indicated:

Without wear rings Last digit of part no. _ _ _ _ _ _ 0
With wear rings Last digit of part no. _ _ _ _ _ _ 9

For wear ring housing details please see datasheet.

  • Unit of measurement:
Unit of measurement:

Max pressure

400 Bar

Temp range


Max speed

  • Recomended
  • Possible
  • Not Suitable

* For fluid types marked as possible, please call our team of experts on (02) 9620 7300 to talk through your requirements and determine if this seal is the most suitable for your needs.

  Dynamic application Static application
Fluids based on mineral oil    
Any Recommended Recommended
Waterbased fluids    
HFA (5/95) Possible Recommended
HFB (60/40 invert emulsion) Recommended Recommended
HFC (water glycol) Not suitable Not suitable
Water Possible Recommended
Other fluid types    
Air/Nitrogen Not suitable Possible
HFD (Phosphate ester ARYL Type) Not suitable Not suitable
Synthetic esters (HEES, HFDU) Possible Possible