839 Wiper Seal

The Hallite 839 double-lipped, snap-in wiper is designed to fit standard housings, including many ISO 6195C sizes, and to exclude dirt and moisture from entering the cylinder. The design minimises the oil transfer out of the ram on the cylinder rod by collecting traces of fluid passing the rod seal.

Opposite the wiper lip are two sealing lips that are precision trimmed at an angle to give optimal rod sealing performance. The Hallite 839 is designed to have an interference in the seal housing groove to improve the stability of the wiper in the gland and to reduce the possibility of ingress around the outside of the wiper.

The Hallite 839 is moulded in Hythane® 181, Hallite’s high-performance polyurethane, for maximum wear resistance.

Hallite recommends a vent is provided between the seal and the wiper to avoid a pressure trap. For customers that require a wiper for heavier duty applications, the Hallite technical team may advise you to use a Hallite 844 wiper instead of the Hallite 839. Contact your local Hallite team for more information.

  • Unit of measurement:
Unit of measurement:

Temp range

-45°C
110°C

Max speed

4m/sec
Key:
  • Recomended
  • Possible
  • Not Suitable

* For fluid types marked as possible, please call our team of experts on +1 248-668-5200 to talk through your requirements and determine if this seal is the most suitable for your needs.

  Dynamic application Static application
Fluids based on mineral oil    
Any Recommended Possible
Waterbased fluids    
HFA (5/95) Possible Possible
HFB (60/40 invert emulsion) Possible Possible
HFC (water glycol) Possible Possible
Water Possible Possible
Other fluid types    
Air/Nitrogen Recommended Possible
HFD (Phosphate ester ARYL Type) Not suitable Not suitable
Synthetic esters (HEES, HFDU) Recommended Possible