Characteristics and performance

The Hallite 33 wiper has a lip designed to remove lightly adhered dirt from the rod i.e. mud, dust or moisture.

The wiper is manufactured from a hard nitrile rubber suitable for installing in a grooved housing. Rod diameters (d1) of 20mm and below require a two piece housing.

To prevent dirt passing the outside of the wiper and to reduce the pumping action, the outside diameter is an interference fit with the housing. Certain sizes of the standard Hallite 33 metric range are suitable for ISO6195 Housing Type A.

Product details

It should be noted that the Hallite 33 inch profile differs from the metric profile. Many of the metric sizes are also available as polyester wipers – see Hallite 38.

Ask an expert

Temp range

-30°C
100°C

Max speed

4m/sec

* Max pressure stated is dependant on the material variant selected. Please consult the datasheet for further information.

Key:
  • Recomended
  • Possible
  • Not suitable

* For fluid types marked as possible, please call our team of experts on +49 (0)40 73 47 48-0 to talk through your requirements and determine if this seal is the most suitable for your needs.

 Dynamic applicationStatic application
Fluids based on mineral oil  
AnyRecommendedPossible
Waterbased fluids  
HFA (5/95)PossiblePossible
HFB (60/40 invert emulsion)PossiblePossible
HFC (water glycol)RecommendedPossible
WaterPossiblePossible
Other fluid types  
Air/NitrogenRecommendedPossible
HFD (Phosphate ester ARYL Type)Not suitableNot suitable
Synthetic esters (HEES, HFDU)PossiblePossible